(SKU:RB-01C016)Ethernet Shield For Arduino
The Arduino Ethernet Shield gives you an easy way to get your Arduino Online. It uses Arduino official Wzinet W5100 ethernet chip (not cheap ENC28J60) And it is directly supported by Arduino official Ethernet Library.
The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield.
The SD card is not supported in this version.
Technical parameters and performance
Power supply: 5v DC Interface: SPI(Ethernet & SD card) Support SD card Support up to four simultaneous socket connections Compatible with Arduino standard version/Mega series Size: 72x55x32mm
1 network expansion board and UNO spliced together, to ensure the normal pin connection.
2. Connect UNO and PC as shown in figure, download code to UNO controller
3 the network expansion board uses the network cable and the computer connection
4 set the local computer network
5 after setting the W5100 network expansion board, the 4 LED will be on the light, if not, press the reset button
6 now read out the IP address of the W5100 extension board
7 through the computer can access the W5100 network expansion board
Arduino Ethernet and Arduino UNO
Arduino Ethernet and Arduino MEGA2560
Buy address：Ethernet Shield For Arduino