(SKU:RB-02S061)Force Sensitive Resistor -Square

From ALSRobot-Wki
Jump to: navigation, search


RB-02S061.jpg

Contents

Product overview

The Force Sensing Resistor is a famous Interlink Electronics company produces a light weight, small volume, sensor with high precision, ultra-thin resistive pressure sensor. This kind of pressure sensor is to take place in FSR film sensor area pressure into the change of the resistance value, thus for pressure information. The lower the pressure, the greater the resistance. Allow its use in place of pressure 0 g - 10 kg. Can be used in the mechanical gripper sensor for holding items at the end, the bionic robot first step ground sensors, mammals bite test of biological experiments, application scope and widely. But as a result of stress testing is not very accurate, so is not recommended requires precise testing pressure.

specification

  1. total length: 3.5"
  2. total width: 1.75"
  3. Detection range: 1.75x1.5"

Method of use

Large FSR Arduino Hookup-400x241.jpg

Module test

/*****************************************************************
机器人基地 RobotBase www.robotbase.cn
目    的:  压力传感器测试程序
目标系统:  Carduino UNO R3 控制器
应用软件:  Arduino IDE 1.0.5
发布时间:  2015-1-23
说    明:  若用于商业用途,请保留此段文字或注明代码来源
	         哈尔滨奥松机器人科技有限公司保留所有版权
*****************************************************************/ 
void setup()
{
  Serial.begin(9600);
}
void loop()
{
  int FSRReading = analogRead(FSR_Pin);
   Serial.println(FSRReading);
  delay(250);
}

Results: through a serial port window, can see numerical is changing with the change of pressure sensor.

Related to recommend

Buy address: [1]

Personal tools
Namespaces

Variants
Actions
Navigation
Tools